CM10 Cable Tray Straight Sections
0.120 Gauge Powder Coated Cold Rolled Steel - Wide Variety Of Sizes
CM10 Series Cable Tray Features
- Powder coated for a smooth and burr free surface
- Corrosion is minimized due to powder coating
- 2" x 2" Grid Pattern Mimizes Cable Sag
- Fabricated From 11 Gauge Steel
- Ideal for Fiber Optics & as Tray Separator
- Availabe in 5 Standard Colors: Yellow, White, Chrome & Black
- Custom Colors Are Available With Additional Lead Time
- Made in the USA
MADE TO ORDER
Products Ship in 5-7 Business Days
Non-Cancellable & Non-Refundable
Manufacturer Recommends Supports Every Five Feet
Pro-CM10 Series Cable Trays - Straight Sections CM10 Cable Tray straight sections(0.120) are designed and have a grid pattern of 2" x 2". They can be used for the support of fiber optics and as tray separators. They are available in industry standard widths of 2", 4", 6" and 8". Available lengths are: 1', 2', 5', 8' and 10'. Height/Depth measurements are 2" or 4". Available colors: Yellow, Chrome, White & Black, red, blue, white, and orange.. Call us with your custom requirement if the above standard dimensions are not suitable for your application. Interconnecting hardware is included. CM10 is not UL classified.
Are we missing the specification you need? Please go to our Contact Us page and submit your question to us, or call 1-877-284-7760
PRO-10TM is available in wire diameter choices CM10 (0.120) - to accommodate various cable tray load capacities. No cutting or bending is required on any of these styles.
The PRO-10TM CM10 cable tray, with a 2"x2" grid pattern, is the lightweight solution for fiber optic cabling that minimizes cable sagging or dropping. CM10 cable trays come in widths of 2", 4", 6", 8" or 12"; lengths of 1', 2', and 5' with depths of 2" or 4". CM10 is not UL-classified®.
PRO-10TM should be installed from the originatinghead-end i.e., the electrical or telecommunications closet. Once the pathway has been established, it is important the layout of the pre-fabricated junctions be installed first. This allows for field measurements to be taken before installing the cable tray. If the straight sections are installed first, it will cause unnecessary field adjustments. Each section has loops at each end. When the sections are connected, the loop on the bottom aligns under the galvanized masked area of the adjoining section. The loop on the side slides into the outside loop guide. Once the trays are aligned, install the 5/16" carriage bolt (included) through the loops with the threaded end to the outside of the tray. Install and tighten the flanged nuts with a 1/2" socket. This reduces the chances of damage when pulling the cables. It is not recommended that the cable tray be cut as it will interfere with the grounding characteristics and UL classification®.PRO-10'sTM wire grid cabletray systems require only one tool and very few accessory items for installation. Pre-fabricated junctions/intersections reduce 50% or more labor hours by eliminating cutting and fabrication in the field. With center hung, trapeze, wall or floor mount accessories, PRO-10TM is prepared to handle the toughest installations.
Looking for a quotation ? We would be happy to help by providing a quick response, inventory status, and Volume Level pricing, when available. Please fill out the form below and a representative will be in touch with you within hours to one business day to answer any questions and quote your request.
Frequently Asked Questions
Have a question that is not answered here? Please go to our Contact Us page and submit your question to us.